Cart

VSM Large Bore Aluminum Paddle Sample Holder (P125D) Part Number: 4096-635
Quantity Included: Each

PRS L100 F500 TL Part Number: PRS-L100-F500-TL
Quantity included: 1 - 20
Piezoresistive 100x48 μm self-sensing silicon tipless (TL) cantilever
Leaflet/Specs

PRSA L400 F30 SCD Part Number: PRSA-L400-F30-SCD
Quantity included: 1 - 20
Piezoresistive 400x100 μm self-sensing silicon cantilever with a single crystal diamond (SCD) tip bonded on our standard PCB (6x5 mm) with a 10 pin connector
Leaflet/Specs

VSM Oven Dry Mount Kit (P540) Part Number: 4097-002
Quantity Included: Each
For use with samples that are affected by the moisture and heat involved in mounting with Zircar cement. Includes dry mount plates, staples and copper foil coupons.

PRS L100 F500 SCD Part Number: PRS-L100-F500-SCD
Quantity included: 1 - 20
Piezoresistive 100x48 μm self-sensing silicon cantilever with a single crystal diamond (SCD) tip bonded on our standard PCB (6x5 mm) with a 10 pin connector
Leaflet/Specs

PRSA L300 F50 SCD Part Number: PRSA-L300-F50-SCD
Quantity included: 1 - 20
Piezoresistive 300x100 μm self-sensing silicon cantilever with a single crystal diamond tip (SCD) and a heater bonded on our standard PCB (6x5 mm) with a 10 pin connector
Leaflet/Specs

MPMS3 Quartz Paddle Sample Holder (C130A) Part Number: 4500-604
Quantity Included: Each
4mm wide

Gelatine Capsules (AGC1) Part Number: AGC1
Quantity Included: Set of 100
Fits well in sample straws (AGC2) and brass large bore sample holder. ~15 mm long and ~5 mm diameter.

MPMS3 ETO Sample Rod (M606) Part Number: 4505-700
Quantity Included: Each

MPMS3 Brass Half-tube Sample Holder (C130B) Part Number: 4500-608
Quantity Included: Each
3.5mm inner diameter

Gelatine Capsules (AGC1) Part Number: AGC1
Quantity Included: Set of 100
Fits well in sample straws (AGC2) and brass large bore sample holder. ~15 mm long and ~5 mm diameter.

VersaLab VSM Oven Sample Rod (V532) Part Number: 4097-075
Quantity Included: Each

VersaLab VSM LBC Guide Tube (V536D) Part Number: 4096-675
Quantity Included: Each
inner diameter of blue tubes = 10.3mm

MPMS3 Oven Copper Foil Coupons (C146) Part Number: 4505-141
Quantity Included: Set of 10
17mm x 30mm foils

MPMS3 Oven Heater Stick (C145) Part Number: 4505-263
Quantity Included: Each
5mm wide

PRSA L300 Fxx Si Part Number: PRSA-L300-Fxx-Si
Quantity included: 1 - 20
Piezoresistive 300x100 μm self-sensing silicon cantilever with silicon tip and meander shaped heater
Leaflet/Specs

SS Starter Kit Pre-Amp v3 Part Number: SS-Starter-Kit-Pre-Amp-v3
Quantity included: 1 - 20
The kit consists of:
1.) Pre-amplifier [BW: 2.5 MHz, low noise, 100x gain, fixed 2V or flexible bridge supply voltage, onboard as well as external offset voltage],
2.) Flex counter part PCB [l=12cm],
3.) Output cable [shielded, l=100cm] and
4.) 2 boxes a 10 pieces self-sensing standard cantilevers (Si-tip or tipless), same type (=> please specify cantilever type when order).
Leaflet/Specs

EXPLORE

CATEGORIES

CONTACT